50W LED Flood Lights China Factory
With ultra high brightness 110 LM / W, our ultra wide LED flood lights is suitable for wall lighting, sculpture lighting and garden lighting applications.The flood lamp has uniform illumination pattern.The module LED floodlight adopts the thick streamline heat dissipation structure, which has...
With ultra high brightness 110 LM / W, our ultra wide LED flood lights is suitable for wall lighting, sculpture lighting and garden lighting applications.The flood lamp has uniform illumination pattern.The module LED floodlight adopts the thick streamline heat dissipation structure, which has high heat dissipation efficiency, light weight and low cost, which is beneficial to the popularization of LED flood lights outdoor.
50 W LED Flood Lights China Factory
1. Compact lamp body, small volume, high container lading rate, up 20%.
2. High Brightness LED Chip>110lm/W, 200-700lm / pcs, Ra>70.
3. Well-known brand driver, not dimmable / dimmable optional.
4. Built-in Unique Reflector, Make Surface Lighting Evenly.
5. Excellent Heat-Dissipation, Low Luminous Decay.
6. IP 66, long life span > 50,000 hrs.
The reasons why LED floodlights are not work:
1. The power supply is broken, no electricity: The essential problem is basically the power supply, the power supply as a power source to provide a constant current operating voltage, usually for most floodlights, the damage is the power driver. The other reason is that the power supply is good. It appears that at the beginning, the LED flood lights can light for a while and then start to flash. This is mainly due to the fact that the heat from the LED chips has not been emitted, and it keeps flashing. Another reason is that the temperature difference between winter and summer in some regions is big, resulting in the power supply operating temperature is too high or too low, and can not be stable operation.
2. The light source is broken, and the light is not work: The general flood lights uses an integrated LED chips, the current of the power supply is too high, and the lamp bulb is open circuit or broken. There is also reason that the waterproof function is not done well, the water inside the lamp,then the LED chips burned; the chip life is not long, poor quality and other reasons.
3. Welded wire solder joints, resulting in non-powered: floodlights inside the integrated chips is to take two lines, whether the lamp chips are false welded, cold welded, whether the power input line has loose connection, open circuit, etc. , whether the drive cable is damaged or not.
4.Finally, LED floodlights belong to high-power LED products. Good quality floodlights undergo a rigorous aging test before leaving the factory, guaranteeing that they are good products to consumers. If there is a problem, contact us immediately after the occurrence of the problem.